Finishing a 80% ar-15 part 1 of 2

Finishing a 80% ar-15 part 1 of 2

Part 1 of finishing a 80% ar-15 on a milling machine.
Thank you all for watching and leave a like….(or dislike) so I know how good or bad my video was and whatever’s on your mind leave it in the comments.

part 2: https://www.youtube.com/watch?v=9auOeEzXnjk&t=3s

Twitter: https://twitter.com/ShootingtipsT

instgram: https://www.instagram.com/shootingtipsandtricks/

If you like my videos and feel like sending me a tip: https://www.patreon.com/user?u=4342755

11 Comments

  1. Chargerus Prime 4014 on September 21, 2022 at 8:13 pm

    Can I do this with just a regular drill press or do I need something else?

  2. Skip Cox on September 21, 2022 at 8:16 pm

    What are the 2 drill bit sizes? Thanks. Great Video

  3. Carl Hall on September 21, 2022 at 8:17 pm

    What bits do you use on the aluminum, looks like 2 flute.

  4. Mr. M.O.G.O.M. on September 21, 2022 at 8:32 pm

    Hello. Where did you purchase the lower?

  5. L. B. on September 21, 2022 at 8:43 pm

    Ar 15 80 upper kit

  6. KOMBATboiiii on September 21, 2022 at 8:46 pm

    Could I use a $100 drill to do this

  7. Mogman150 on September 21, 2022 at 8:46 pm

    When drilling, how close do you come to the finished dimension (depth and location)? I assume you leave ~.030?

  8. James Halbert on September 21, 2022 at 8:49 pm

    is no cutting fluid necessary?

  9. KOMBATboiiii on September 21, 2022 at 9:04 pm

    Could I use a $100 drill presss to do this also how about a router ?

  10. Nubia Gonzalez on September 21, 2022 at 9:09 pm

    Hi, could you help me tell me by centimeters or inches how deep is the trigger and also cm or "from each of the holes and their distance or measure

  11. Bruce Janacek on September 21, 2022 at 9:10 pm

    What moron would reach into a spinning tool and grab string chips bare handed. Can’t watch another second. Tool maker here of 40 years.

Leave a Comment